X-BULL Gen 2.0 Recovery Tracks, 2 Pairs with Mounting Pins, Red

Two pairs (four tracks) of 91cm X-BULL Gen 2.0 recovery tracks in red, with two sets of mounting pins to carry them on your roof rack.

Recovery tracks go under your tyres when you are bogged and give them something to grip, so the vehicle can drive itself out. These X-BULL Gen 2.0 tracks are moulded from reinforced nylon and measure 910 x 310 x 60mm, with raised cleats on top, a cruciform grip pattern underneath and moulded handles.

The lower-profile ends can be used to dig sand or mud away from the tyres before you place the tracks. The supplier rates the tracks to carry vehicles up to 10 tonnes on flat ground.

With four tracks you can put one under each wheel, or share them between two vehicles travelling together.

Each of the two mounting pin sets (4 pins, 8 nuts and 8 flat washers) holds one pair of tracks, so both pairs can be bolted to a roof rack or base and are ready when you need them.

• X-BULL Gen 2.0 tracks, 910mm long
• Reinforced nylon with UV resistance (supplier)
• Raised U-shaped cleats on top grip the tyre and help reduce side slip
• Cruciform pattern on the underside bites into sand, mud and snow
• Moulded ergonomic handles for placing and pulling the tracks
• Ends double as a shovel for clearing around the tyres
• Load rating of 10 tonnes on flat ground (supplier rating)
• Two mounting pin sets with anti-rust coated hardware
• Finished in red

Brand: X-BULL
Model: Gen 2.0
Colour: Red
Tracks included: 4 (2 pairs)
Track size: 910 x 310 x 60mm (approx. 91cm long)
Material: Reinforced nylon
Load rating: 10 tonnes on flat ground (supplier rating)
Gross weight: Approx. 4.7kg per pair, packed (supplier)
Carton size: 920 x 320 x 125mm per pair (supplier)
Mounting pin set: 4 pins, 8 nuts, 8 flat washers per set
Pin set size: 13.8 x 10.8 x 6.2cm (supplier)
Pin set weight: 0.72kg (supplier)

• Beach and desert driving
• Muddy tracks and wet-season trips
• Snow and alpine trips
• Remote outback touring
• Towing campers and caravans on soft ground

Getting bogged on a remote road, or while leaving during a flood or bushfire, can leave you stuck with no help nearby. Recovery tracks let you self-recover in many soft-ground situations without a second vehicle or a winch.

• 4 x X-BULL Gen 2.0 recovery tracks (red)
• 2 x mounting pin sets (each with 4 pins, 8 nuts and 8 flat washers)

Leashes and carry bags are not included. Accessories or items shown in promotional imagery are not included unless listed above.

The 10-tonne figure is the supplier's load rating on flat ground. Recovery tracks are traction aids only. They are not designed for lifting, for bridging gaps, holes or ditches, or for use as ramps or jacking bases beyond the manufacturer's stated use.

To use: clear sand or mud from in front of the tyres, wedge the tracks firmly against the tread, lower tyre pressures where appropriate, then drive on slowly with as little wheelspin as possible. Heavy wheelspin can wear or melt the cleats.

Keep bystanders well clear while driving onto the tracks, as a track can be flicked out from under a spinning tyre.

Inspect the tracks for cracks, broken cleats or other damage before each use and replace them if damaged. Rinse off sand, salt and mud after use and store out of direct sun when not needed.

The mounting hardware has an anti-rust coating and may look darker than in the photos. Check it suits your roof rack or base, and re-check nut tightness regularly, especially on corrugated roads.